If true response to the controller will always use the specified port and not the one from where the telegram is received. This depends on the controller configuration.ĭefault is false. The default is to use checksum in the telegrams, but it can be ignores and replaced by “NC” in the telegrams. If set to “Auto”, the type will be set automatically. The ID can be found on the controller itself, 4 digits like “027j”.Īuto or PTF-L-1/PTF-L-6/PTF-L-7/PTF-3N-1/PTF-3N-1 This is a unique ID for the KBS controller. is the type of display on the cart (legal: PTF-L-1) Configuration are done in the SHARK registryįrom the Maintenance -> System Configuration menu. There are a few special configuration parameters, only Configure as with the Telnet connection.Ĭonfiguration of the units in Shark is described under the Pick-To-Lightĭocumentation.Press “x” and turn on the terminal simulator.Set the communication parameters to: 9600 Use a Hyberterminal or a similar terminal semulator and connect to.Connect a serial port from a PC to the Lantronix box.If it is not possible to assign an IP address, a serial cable can be Use the telnet connection to change the setup to:Ĭonfigure the Wifi network according to the installation site. Use the tool SETIPPARAM from KBS/Lantronix. Use the Lantronix software to assign one. Use a port scanner to find the correct MAC address. If the IP address is not known, it can be found in different ways.ĭefault the interface is configured with DHCP, so it will be assign a Or by browser access: Default password is: kbs8, user name empty. The wireless Lantronix gateway must be configured correcly before use. This setup make use of UDP communication from the Shark Device Server to That a unit is supported, does not mean that all functionality the unit This chapter describes how to configure the pickcart from KBS based on SHARK might also use the KBS light to a pick-table directing the pick to the correct order boxs.Įxample where the module is used for pick-by-light in a flow-rack Installation and Configuration Configuration of the controller It can be used for both Pick Carts using a WIFI connections or for a fixed mounted controller servicing pick-by-light on the shelving.
PickTermFlexible controller from KBS by the SHARK Device The pick-by-light module PickTermFlexible2 is used for controlling the
0 kommentar(er)
